The High Sierra Sidekick antenna is a portable antenna system designed for
satellite communications and is widely used in military, emergency response,
field operations and other fields. To ensure that you can correctly install and
use this antenna, the following are some key steps and precautions based on the
operating guide of general portable satellite communication antennas. Please
note that the specific model and version may vary, so it is recommended to refer
to the official user manual that comes with the product for the most accurate
information.
High Sierra Sidekick Antenna Operating Guide
1. Package Inspection
After unpacking the box, carefully check that all components are complete
and confirm that there is no damage. A typical Sidekick antenna package usually
includes:
Antenna unit
Bracket and base
Connection cables (such as LNB cable, power cord, etc.)
Tool kit (screwdriver, wrench, etc.)
User manual and warranty card
2. Choose the installation location
Flat ground: Choose a solid and level surface for installation, and avoid
operating on slopes or unstable ground.
No obstacles: Make sure there are no large obstacles around the antenna
that block the line of sight to the satellite.
Stay away from interference sources: Try to stay away from other electronic
devices, power lines, and other places that may generate electromagnetic
interference.
3. Assemble the bracket
Connect the bracket parts as shown in the instructions, making sure all
bolts are tightened in place.
If necessary, use the provided tool to adjust the angle of the bracket for
more precise satellite alignment later.
4. Install the antenna unit
Install the antenna unit on the top of the bracket and secure it with the
provided fixings.
Pay attention to the directionality of the antenna and make sure that its
front is facing the expected azimuth direction of the satellite.
5. Connect the cables
Use the provided cables to connect the antenna to the receiver or other
related equipment. Make sure all connections are secure and properly
waterproofed.
For some models, you may also need to connect a power cable to power the
antenna.
6. Calibration and alignment
Initial positioning: Use a map application or satellite finder to determine
the azimuth and elevation of the satellites at your location.
Fine-tuning: Adjust the direction of the antenna by manually rotating the
bracket until the strongest signal is received. Many systems have a signal
strength indicator to help with this step.
Lock the position: Once you find the best signal point, immediately lock
all adjustments on the bracket to prevent wind or other factors from causing the
antenna to move.
7. Testing and Verification
Start the receiving device and check whether the expected satellite signal
can be stably received.
If you encounter problems, refer to the troubleshooting section in the user
manual or contact technical support for help.
8. Removal and Storage
After use, remove the antenna and its accessories in reverse order and
store them properly to avoid damage caused by sun and rain.
Precautions
Safety first: Always pay attention to personal safety during installation,
especially when working at height.
Comply with regulations: Make sure your device configuration complies with
local laws and regulations on the use of radio frequencies.
Regular maintenance: Keep the antenna clean and dry, and regularly check
whether the connecting parts are loose.
Home >
+86-13570817400
